Linear Feed Axis Servo Drive Technology And Its Control Mode

Jan 22, 2026 Leave a message

Since the birth of CNC machine tools, their feed drive technology has gone through three stages: stepper motor-driven feed axis servo systems, closed-loop DC servo systems, and the currently widely used AC servo systems. Despite the continuous development and changes in feed drive technology, its basic transmission method has always been the "rotary motor + ball screw" mode, with the movement trajectory of controlled objects such as tools and worktables being linear. Linear motion can only be indirectly obtained through intermediate mechanical conversion, which brings a series of problems.

 

T6M 2 -
T6M 2
T6M 1
T6M 3

Intermediate transition links reduce the rigidity of the transmission system, especially since slender ball screws are weak points in rigidity. Energy consumption during the initial starting and braking phases is spent overcoming the elastic deformation of intermediate connecting rods, which is also a source of mechanical resonance in CNC machine tools. Secondly, intermediate links increase the inertia of motion, slowing down the system's speed and displacement response. Due to manufacturing precision limitations, dead zones and friction are unavoidable. What information can be obtained from nonlinear hexagonal palm, field, snow, and low-dust magpie systems? With the development of high-power semiconductor and computer technologies, control devices and control principles are constantly being updated and improved. In particular, the widespread application of PWM modulation technology has led to the increasingly mature control theory and technology of three-loop structure (position loop, speed loop, and current loop) position servo systems, achieving a high level of rapid and accurate positioning.

 

With the rapid development of high-speed and high-speed precision machining technologies, higher demands are placed on the feed drive systems of CNC machine tools. The feed speeds achievable by traditional drive methods are far from meeting the requirements of high-speed cutting.

 

To adapt to the needs of modern machining technology, the feed axis servo directly drives the worktable instead of using a "rotary motor + ball screw" method. Therefore, a new linear feed axis servo technology that eliminates intermediate transformation links has emerged. This paper first introduces linear feed servo drive technology and its current application status, demonstrating how a linear feed servo drive is implemented using a linear AC servo motor. A servo motor can be viewed as a linear motor with the stator of a rotary motor extending radially, expanding the circumference into a straight line as the primary stage, and using a conductive metal plate instead of a rotor as the secondary stage. A three-phase winding is embedded to form the mover, which is connected to the machine tool's moving table. The second stage, as the stator, is fixed to the machine tool's guide rail, with an air gap of approximately 1mm between them. Currently, the linear motors used in CNC machine tools mainly include induction linear AC servo motors and permanent magnet linear AC servo motors. Induction linear AC servo motors generally use SPWM frequency conversion power supply and secondary magnetic field-oriented vector transformation control technology, which can quickly and accurately control parameters such as movement position, speed, and thrust.

 

Because the core length of an induction-type linear servo motor is limited, the longitudinal ends open and close, creating an end effect at the two longitudinal edges. This results in unequal mutual inductance between the three-phase windings, leading to asymmetrical motor operation. There are three methods to eliminate this asymmetry: using three identical motors simultaneously, connecting the windings in a cross-series configuration to obtain symmetrical three-phase current; for cases where three motors cannot be used simultaneously, increasing the number of magnetic poles can reduce phase differences; and installing compensation coils outside the core ends.


The above describes the linear feed axis servo drive technology and its control modes. For more information, please feel free to contact us! Our company has many years of experience and looks forward to your joining us.

 

Get a quote