What Are The Advantages Of Bus Servo Systems Over Pulse Servo Systems?

Aug 30, 2025 Leave a message

Bus servo is defined as a control system that enables its output variable to accurately follow or replicate its input variable. With the increasing demand for motion control, servo control has emerged. Servo motors, also known as actuator motors, are used as actuators in automatic control systems to convert received electrical signals into angular displacement or angular velocity output on the motor shaft. They are available in DC and AC servo motors. Their key characteristic is that when the signal voltage is zero, there is no rotation, and the speed decreases at a constant rate as torque increases. Servo positioning primarily uses pulses. Basically, when a servo motor receives a pulse, it rotates by an angle corresponding to the pulse to achieve displacement. Because servo motors inherently transmit pulses, each degree of rotation sends a corresponding number of pulses, forming an echo or closed loop with the pulses received by the servo motor. The system then knows how many pulses were sent to the servo motor and how many were received. This allows precise control of motor rotation to achieve accurate positioning, down to 0.001 mm.

 

In bus servo systems, pulse mode is often used in simple servo applications with low requirements. As we all know, there is a certain time delay between sending and receiving pulses. Bus servo drives in bus control mode (i.e., absolute servos or EtherCAT servos) can achieve true synchronization because bus communication is faster, allowing speed or position settings to be sent directly. Therefore, servo applications are based on bus control.

 

Bus servo drives offer strong flexibility and high cost-effectiveness. Compared to pulse-type servo drives, their advantages are as follows:

 

1. Reduced wiring costs and time, and lowered error probability. A single bus communication port on the controller can be used to connect multiple servos, while a simple RJ45 port can be used to connect servos, shortening the installation cycle.

2. More information: Fully digital information exchange allows for bidirectional transmission of numerous parameters, commands, status, and other data. Pulse mode transmits position or speed information in only one direction and cannot obtain additional servo status or parameters.

3. High-precision, digital communication: No signal drift, command and feedback data accuracy up to 32 bits.

4. High reliability, strong anti-interference capabilities, and no pulse loss. However, pulse/direction control becomes unreliable at high speeds.

5. Bus servo reduces total system cost. When there are more than two servo mechanisms, there's no need to adjust the controller configuration. Pulse-type servos require additional pulse or axis control modules. When there are multiple servo systems, even higher-level controller hardware is required to meet the requirements.

6. Bus servo enables the development of devices with more powerful software without the need for additional hardware or wiring: The controller monitors servo motor faults in real time via the bus and displays them on the teach pendant. It also monitors the servo motor's actual position, speed, and other information, and can automatically adjust servo parameters as needed through the program. Servo parameters can be set on the teach pendant, eliminating the need to modify them on the servo panel. This is simple, intuitive, and error-prone.

7. Utilizes a standard motion function block library to improve programming and debugging efficiency: The bus system solution avoids the heavy programming and complex debugging associated with traditional pulse-direction control, improving efficiency and saving both cost and time.

8. Remote control is possible, making it particularly convenient and cost-effective for long production lines or large numbers of servo devices.

9. It offers enhanced maintainability, status information, and diagnostic information. CNC and motion control using bus control are very popular in Europe and the United States.